Synchronizes motors by returning the table to lowest position. Resetting resolves most mechanism issues. Perform this step once a month, when legs are uneven or not raising.
click to learn more
1. Press the down arrow on switch.
2. Bring table all the way down.
3. Release button.
4. If you’ve already programmed a storage stop,
you will need to continue holding the
down arrow past the storage stop position.
5. Hold down arrow again for 10 –15 seconds until
table moves down, then up slightly (about 1/2" distance).
Default Reset
Prevents table from colliding with lower storage components. To set, table needs to be in the lower half of its adjustment range.
1. Lower the table to the desired height.
2. Press and hold both up and down arrows
simultaneously until you hear two clicks
(about 10 seconds).
To clear, adjust the table to the desired height, press
and hold both up and down arrows simultaneously
until one click is heard (about 10 seconds); the table
can then travel to its lowest range.
Set or Clear Lower Storage Stop
Prevents table from colliding with upper storage components. To set, table needs to be in the upper half of its adjustment range.
1.Raise the table to the desired height.
2. Press and hold both up and down arrows
simultaneously until you hear two clicks
(about 10 seconds).
To clear, adjust the table to the desired height, press
and hold both up and down arrows simultaneously
until one click is heard (about 10 seconds); the table
can then travel to its highest range.
Set or Clear Upper Storage Stop
Saving a height position with the programmable switch
1. Position the top to the desired height.
2. Press the Set (S) button.
3. Within 5 seconds press the desired number key
until a double click is heard.
NOTE: The readout will show, for example, S (number)
until the double click is heard and then the height
readout will return.
Program preset heights
1. Press the appropriate number button.
2. Continue to press the button until the saved
position is reached.
Moving to a preset height
1. Press the 1, 2, and up arrow buttons simultaneously.
2. Use the up and down arrow keys until the readout shows S 5.
3. Press the S button to complete.
4. Use the same procedure to switch back to inches.
Changing from inches to centimeters
(The default is set to inches but can be changed on site to
read in centimeters.)
Program your table
@ 2023 Haworth, Inc.
Cookie Policy
Terms of Use
Privacy Policy
